Drywall Installation Macon GA

Our Drywall Installation Process

Every Macon drywall installation we do follows the same proven seven-step process so the finished walls look perfectly flat under raking light and accept paint evenly. We start by measuring the framed space, ordering the right sheet sizes (typically 4×8, 4×10, or 4×12 sheets to minimize seams), and verifying that studs are on 16" or 24" centers and that any electrical boxes, plumbing, and HVAC rough-ins are complete.

Next we cut and hang the boards. Ceilings go up first using lifts so the panels sit tight against the joists with no sag, then walls follow with butt joints staggered. We screw with collated screw guns set to the proper depth — deep enough to dimple, never deep enough to break the paper face. Then comes taping, three coats of mud, sanding, primer-ready inspection, and final cleanup.

Residential vs Commercial Installation

Residential installations across Macon — bedrooms, bathrooms, basements, additions, garage conversions — typically use 1/2" standard drywall on walls and 5/8" on ceilings. We upgrade to moisture-resistant 'green board' or fiber-cement backer for bathrooms and laundry rooms, and we use 5/8" Type X fire-rated board in garages adjoining living space, per Georgia code.

Commercial installations across the Macon and Warner Robins corridor often require fire-rated assemblies, sound-rated demising walls, and impact-resistant board for high-traffic areas. We routinely build UL-listed assemblies for office build-outs, medical suites, and restaurant tenant improvements.

Ceiling and Wall Work

Ceiling installs are the most demanding part of any drywall project. We use mechanical lifts so panels go up tight and flat, and we always run ceiling sheets perpendicular to the joists to maximize stiffness. Heavy 5/8" board is standard on ceilings to reduce sag, especially in the humid Middle Georgia climate.

Wall installs prioritize minimizing seams. We hang horizontally on standard 8' walls so there's a single butt joint at 4', and we feather every seam wider than the recommended 10" to keep walls flat across the full plane.

Bibb County Code Compliance

Bibb County requires permits for many remodel and addition projects. We're familiar with the local inspection requirements — proper fastener spacing (7" on ceilings, 8" on walls for fasteners), fire blocking, garage separation, and bathroom ventilation. When a permit is required, we coordinate with the inspector so there are no surprises.

Pricing and Project Timeline

Drywall installation in Macon typically runs $1.50–$3.00 per square foot of finished wall and ceiling surface, including materials, labor, mud, tape, screws, and a Level 4 finish. A typical bedroom runs $400–$900. A full basement finish in the 800–1,200 sq ft range usually lands between $4,500 and $9,000.

Timeline-wise, a single bedroom takes 2–4 days start to finish, allowing dry time between mud coats. A basement build-out usually takes 1–2 weeks. We give you a precise schedule during your free in-home estimate.