How Much Does Drywall Cost in Macon GA? (2025 Pricing Guide)

If you're planning a drywall project in Macon — whether it's patching a hole, finishing a basement, or hanging drywall in a new addition — the first question is almost always 'how much is this going to cost?' This 2025 pricing guide breaks down drywall costs in Macon GA so you can budget confidently and spot a fair bid from a bad one.

Average Cost Per Square Foot in Macon

Most Macon homeowners pay between $1.50 and $3.00 per square foot of finished wall and ceiling surface for new drywall installation. That figure includes the drywall itself, screws, tape, joint compound, labor to hang, three coats of mud, sanding, a Level 4 finish, and basic site cleanup. It does not include framing changes, electrical/plumbing rough-in, paint, or texture beyond a standard orange peel or knockdown.

The low end of the range applies to large, open, easy-to-access spaces like a basement with no closets, no soffits, and 8-foot ceilings. The high end applies to tight spaces with lots of cuts, vaulted or 10-foot-plus ceilings, and Level 5 smooth finishes.

Room-by-Room Cost Breakdown

Single bedroom (10×12 with 8' ceilings): $400–$900. Bathroom with green board: $300–$700. Living room or den (15×20 with 8–9' ceilings): $800–$2,000. Full kitchen drywall after a remodel: $700–$1,800. Finished basement (800–1,200 sq ft): $4,500–$9,000 including ceiling. Garage drywall (2-car, 22×22): $1,200–$2,500 with required 5/8" fire-rated board on shared walls.

Materials vs Labor Split

On a typical Macon drywall job, materials make up about 30–40% of the price and labor makes up the other 60–70%. A standard 4×8 sheet of 1/2" drywall costs around $15–$18 at local suppliers in 2025; a sheet of 5/8" fire-rated board runs $20–$25. Joint compound, tape, and screws add another small percentage. The rest is skilled labor — hanging, three coats of mud with dry time between, sanding, and texture.

Factors That Move the Price

Ceiling height, accessibility, finish level, and texture style all shift price. Level 5 smooth typically adds $0.50–$1.00 per square foot. Hand-applied skip trowel or Mediterranean textures add $1.00–$2.00 per square foot. Repair jobs that require demolition or moisture remediation cost more than fresh hangs on bare framing.

Middle Georgia Labor Market

Drywall labor in the Macon and Warner Robins area is generally less expensive than Atlanta. Skilled finishers in our market typically earn $25–$45 per hour depending on experience, which is part of why Macon drywall pricing tends to land at the lower end of the national average.

Red Flags of Low-Ball Bids

Watch for bids 30% below the others, no written estimate, demand for full payment upfront, no proof of insurance, no business license, no local references, vague language like 'finished to industry standard' without specifying a finish level, and any contractor that won't put a workmanship warranty in writing.

Bibb County Permits

Bibb County requires permits for most additions, garage conversions, basement finishes, and any project that involves moving electrical or plumbing. Permits typically run $50–$200 and require inspections at framing and final stages. A licensed contractor can pull the permit on your behalf. Drywall-only repair work usually doesn't require a permit.

DIY vs Hiring a Pro

DIY drywall can save 50% or more on labor, but the learning curve is steep. Hanging is doable for a homeowner with a helper. Taping and mudding is where most DIY jobs fall apart. If you've never finished drywall before, expect to redo a lot of your first wall. Hire a pro for ceilings, anything over 100 sq ft, and any wall in raking light. Call us at (478) 555-0100 for a free Macon drywall estimate.